Start The Year Off With Huge Saving On Goodman's Seer2 Split Systems!

STOREWIDE SALE ADD TO CART TO SEE SAVINGS

2 Ton 14.3 SEER2 Goodman Heat Pump Condensing Unit GSZB402410

2 Ton 14.3 SEER2 Goodman Heat Pump Condensing Unit GSZB402410

Standard Features 

• Energy-efficient compressor
• SmartShift® technology to ensure quiet reliable defrost
• Enhanced aluminum fin coil with 5 mm diameter copper tubes in 1.5- to 3.5-ton
• Single-speed PSC condenser fan motor
• Factory-installed bi-flow liquid-line filter drier
• Factory-installed suction-line accumulator
• Factory-installed compressor crankcase heater
• Factory-installed high-capacity muffler
• High- and low-pressure switches
• Service valves with sweat connections and easy access to gauge ports
• Fully charged for 15’ of tubing length
• Contactor with lug connection
• Ground lug connection
• AHRI Certified; ETL Listed

Cabinet Features

• Removable grille-style top design compliant with UL 60335-2-40
• Steel louver coil guard
• Heavy-gauge galvanized-steel cabinet
• Attractive Architectural Gray powder-paint finish with 500-hour salt-spray approval
• Top and side maintenance access
• When properly anchored, meets the 2020 Florida Building Code unit integrity requirements for
hurricane-type winds (Anchor bracket kits available.)

GSZB402410

  GSZB402410
Nominal Capacities  
Cooling (BTU/h) 24,000
Heating (BTU/h) 24,000
Decibels 74
Compressor  
RLA 8.4
LRA 41.2
Stage Single
Type Rotary
Condenser Fan Motor  
Motor Type PSC
Horsepower 1/6
FLA 0.95
Refrigeration System  
Refrigerant Line Size¹  
Liquid Line Size (“O.D.) ⅜"
Suction Line Size (“O.D.) ¾"
Refrigerant Connection Size  
Liquid Valve Size (“O.D.) ⅜"
Suction Valve Size (“O.D.) ¾"
Valve Connection Type Sweat
Refrigerant Charge (oz.) 92
Electrical Data  
Volts/Phase (60 Hz) 208/230
Minimum Circuit Ampacity 2 11.5
Max. Overcurrent Protection 3 15
Min / Max Volts 197/253
Electrical Conduit Size 1/2" or 3/4"
Unit Weights  
Equipment Weight (lbs.) 160
Ship Weight (lbs) 175

¹ Tested and rated in accordance with ARI Standard 210/240
2 Wire size should be determined in accordance with National Electrical Codes; extensive wire runs will require larger wire sizes
3 Must use time-delay fuses or HACR-type circuit breakers of the same size as noted.
Notes
• Always check the S&R plate for electrical data on the unit being installed.
• Installer will need to supply ⅞” to 1⅛” adapters for suction line connections.
• Unit is charged with refrigerant for 15’ of ⅜” liquid line. System charge must be adjusted per Installation Instructions Final Charge Procedure.
• Installation of these units requires the specified TXV Kit to be installed on the indoor coil. THE SPECIFIED TXV IS DETERMINED BY THE OUTDOOR UNIT NOT THE INDOOR COIL.

Scroll to Top